Low cost alternative for the dual axis CNC controlled ultrasonic cutting table. Equipped with a single cutting axis with both an ultrasonic cutter and a crush cutter for cutting panel blinds, roller blinds and screens. The cutting axis moves over the table to cut pre-programmed panels from the roll. After the first cross cut, each panel is turned 90 degrees and the blind or screen is cut to measure automatically.
The cutting axis is equipped with a clamping system (single sided) to clamp the fabric during cutting. The table top is a multi piece hardened glass plate with a maximum dimension of 4x8m.
Key features:
- Cutting dimensions max 395x790 cm
- Stable steel frame with hard wearing table top to support the glass plate
- Multi piece hardened glass plate.
- Cutting bridge with accurate guiding en single sided clamping system
- Two universal tool supports with an ultrasonic cutters and a crush cutter
- Pneumatic operated end stop for aligning panels
- Sensors for fabric width detection
- Graphical user interface with touch screen mounted on the cutting bridge with software to prevent cutting near glass plate edges, manual or automatic (several orders in one cycle) operation, possibility to work from left to right or from right to left
- Optional: flexible, automatic fabric roll storage system (any number of rolls)
- Machine dimensions depend on cutting dimensions and options
- Power supply 208/230/400V, 50/60Hz, 6 bar air supply
|
|
Video |
 "Single axis ultrasonic cutting table")